September 9th, 2013 Knowing how crucial the z-axis calibration and alignment is, I focused on that today. I manually rotated the z-axis rods to get even pressure on all of...
September 9th, 2013 Knowing how crucial the z-axis calibration and alignment is, I focused on that today. I manually rotated the z-axis rods to get even pressure on all of...
September 7th, 2013 I mounted the extruders, turned on the heaters and attempted to run some filament through them, only to find that the barrels were getting hot enough to...
September 7th, 2013 I mounted the extruders, turned on the heaters and attempted to run some filament through them, only to find that the barrels were getting hot enough to...
August 31st, 2013&September 1st, 2013 I decided to modify the mounting of the LCD/Control panel so that the Z-axis can move all the way up and have plenty of clearence…...
August 31st, 2013&September 1st, 2013 I decided to modify the mounting of the LCD/Control panel so that the Z-axis can move all the way up and have plenty of clearence…...
