Genmitsu GS-775MR CNC Motor
- Experience a quick and easy upgrade for your Genmitsu Desktop CNC. The GS-775M motor fits all Genmitsu 3018 series CNC router machine: 3018/3018-PRO/3018-MX3/3018-PROVer. Easy Installation for a quick swap of the OEM Spindle. This motor with higher speed for you to do more engraving work efficiently.
Note
- Wiring: Red lead connects to the positive pole, and the black lead connects to the negative pole. If the wiring is reversed, the motor will rotate in the opposite direction.
- Overload: Keep the motor is within the specified load range as far as possible. Don't block the motor or keep it run in a stalled status for a long time. Otherwise, the motor will burn out.
Specifications
- Rated Voltage: DC 24V
- No-Load Speed: 20000 RPM
- Motor Size: 43 x 68 mm (D*L)
- Double Ball Bearing Brush
- CW/CCW Rotation
Compatibility
It is compatible with most 3018 Series CNC routers in the market.
High Speed
The motor speed is 24V 20000 RPM, which is 10000 RPM higher than the original CNC spindle motor. You can do much more engraving and drilling work with this great motor.
Application
The motor is suitable for desktop drilling machines, desktop milling machines, CNC router machines, cotton candy machines, small lathes, precision machine battery vehicles, toy cars, etc.
Specifications
- Spindle Motor: GS-775M
- Pre-Installed Motor Noise Suppression board
- Spindle RPM: 24V 20,000
- High Speed – Low Noise
- Double Ball Bearing Brush
- CW/CCW Rotation
- Collet Holer Installed Already
What's in the box
- 1x Genmitsu GS-775M CNC Spindle Motor with Collet Holder Installed
- 1x ER11 Collet (5mm)
FAQs
Can this work with 3018-PRO Offline controller?
About using your 775 Spindle Motor
One of the key attractions of this upgraded spindle is the ability to turn at 20,000 RPM. What you may find the first time you try to utilize the spindle at it's maximum speed is that it will not turn properly.
Please do not be alarmed. What is happening is that the current being drawn when the spindle tries to go from 0 to 20,000 RPM is more than the 5A power supply that came with your CNC can provide for that moment of peak power draw.
That being said, if you ease the spindle into the maximum RPM, everything works without issue. How we suggest you do this is by replacing your spindle speed command with a few extra lines of code which brings your spindle up to full speed over the course of a second. In order for this code below to work, make sure to set $30=10000 in your console. This sets the maximum spindle speed in your firmware.
So S10000 M3 is replaced with:
S4000
M3
G4 P.25
S6000
M3
G4 P.25
S8000
M3
G4 P.25
S10000
M3
An alternative is to replace the stock power supply with one having greater current capacity (24V 8-10A), but that may burn out the controller with an abrupt 100% speed command.
However, a larger power supply should provide more cutting power from the GS-775M spindle, but the power-up sequence shown above is still recommended.