Filter
Sort
-
SD03A, 1/4'' Shank & Cutting, 1-Flute, Spiral Downcut Cutter, 3-Pack
High Quality: High Quality: The Genmitsu end mills are made of Tungsten Carbide Steel and 0.2um ultra-fine 0.2μm tungsten carbide steel alloy that can keep continuous machining 800 minutes. Moreover, its Nano Blue Coating provides high hardness, and heat resistance enables the tool's cutting edge to retain crucial sharpness and lubricity. This provides longevity and produces cutting results of the highest quality.
Down Cut Advantage: Downcutting bits press the chips and the material back into the cut, thus leaving a nice finish on the top surface of your material. Generally used for smoothly downcut groove and slots, mortises, cycles, and dados, plunge cut leaves with a clean edge and top surface, better than straight bits.
Cost-Effective: It comes with 3PCS of the single flute spiral down-cut bits with different cutting lengths and overall length to meet your requirements. Shank Diameter: 1/4''(6.35mm), Cutting Diameter: 1/4''(6.35mm), Cutting length: 12/17/22mm, Overall length: 50/60mm.
Applicable Materials: Perfect for cutting thin, flexible materials including aluminum, wood, plastic, laminated materials, and thin & flexible sheets, etc.
Wide Compatibility: The SD03A down-cut spiral bits are compatible with most desktop CNC machines, such as the Genmitsu 3018 Series, as well as other industrial CNC machines. Just make sure you select the correct-sized collet for your device.
$24.99
-
Sale
Sale
FT Series, 1/4'' Shank, Spiral Flush Trim Router Bit for Handheld Routing, 1Pc
There are two independent ball bearings at the tip ensure smooth running. Flush trim all types of material for a perfect finish. It is made of Tungsten Carbide Steel Alloy and designed with the Nano Blue Coating wear resistance. With the sufficient flexural strength and wear resistance which ensure high efficiency, also provides precise, efficient cuts and offers extreme durability.
It can be used with handheld, table-mounted and CNC routers. Cut half-round grooves for fluted moldings, columns, millwork and signs using a core box bit. It can cut coves if used with an edge guide. Widely suitable for boring, milling, drilling, silk attack, sculpture, CNC, and other processing. Perfect for soft & hard woods, ply-woods, composites, laminates, plastics and some non-ferrous metals.
$9.99$19.99